Measuring
Decide on the height of your rails. A dado rail should be fitted between 1 and 1.2m (1.1 and 1.3yd) from the floor. A Victorian or older house with high ceilings should have the picture rail at a height somewhere between 300 and 500mm (12 and 20in) below the ceiling. 1930s-to-present homes have lower ceilings and the picture rail is usually level with the top of the door frames.
Use a tape measure and mark the wall at the correct height. Make marks every 1.5m (1.6yd) around the room. Work from the ceiling down for picture rail and from the floor up for dado rail.
Rest a spirit level on top of a piece of the rail and use this to join up the points you have marked. You may need to slightly adjust the line if your floor or ceiling isn't level.
|
Screw holes
Make screw holes at 1m intervals along the centre of the rail with a wood bit. Countersink the holes so that you can cover the screw heads with filler.
Tip: Pre-packed dado
and picture rails sold in DIY stores come with hidden plastic fixings that don't need screw holes
in the wood.
|
Drilling
Start at the corner of the longest length of plain wall and mitre the end of the first rail using a saw and mitre box.
Hold the rail against the wall with the top edge lined up with your pencil line. Mark through the screw holes with a pencil.
Drill the fixing holes in the wall at the marked points. Use wall plugs for brick walls or cavity wall fixings for plasterboard walls.
Tip: Try to buy full lengths of rail so that you don't have to join pieces in the middle of the wall. If your room is very long, mitre the other end of the first rail as well. Then mitre the end of the next piece of rail to make a neat angled joint.
|
printer friendly
send to a friend
Delicious
Digg
reddit
Facebook
StumbleUpon
